Sponsored By

Sign in to follow this  
CsrLiz344

Windows update/configuration problem

Recommended Posts

Apparently Windows did an update night before last, I have Windows 7 Home Premium, and now when I turn on my computer it will try to configure them. It sits there for about 10 minutes on 0%, then say it failed, and revert back, How can I take it out so it can try it again?

Share this post


Link to post
Share on other sites

About two days ago I noticed a few new updates and decided to install them all. Unfortunately, I ran into a similar issue. On reboot, the updater reported that a problem was encountered and reverted to a pre-update state.

I eventually got all the updates installed by doing the following. I went into WU and saw that only one of the important updates was selected by default. I allowed this single update to install and reboot the system. Afterward, applying the other updates was successful.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this